I recently bought an odroid c2 for use as a home server and other various things. However, upon installing Armbian and updating Ubuntu (16.04), I found that the bridge would stop working between reboots. I never got to the bottom of it, but I found this workaround.
If you are doing this on a machine which you cannot physically access, I'd suggest stopping/removing Network Manager only when you've set it up and not before you follow this.
Firstly, I just removed Network Manager
sudo apt-get remove network-manager
Then, I enabled the systemd network service
sudo systemctl enable systemd-networkd.service
I was a bit worried if the resolvconf for Ubuntu would continue or stop working, so I did this to avoid any risk
sudo systemctl enable systemd-resolved
sudo ln -sf /run/systemd/resolve/resolv.conf /etc/resolv.conf
Get the name of your network interface by running the following command
ip addr show
There are 3 types of files that systemd uses for configuring this, but we only need two. .network files will apply the configuration of a matching device name and .netdev will create the network device for the matching environment (in this case, that's the bridge)
So, we'll start by creating the file for eth0 (which was my device in this case). /etc/systemd/network/uplink.network
Then /etc/systemd/network/br0.network (Use the settings applicable to your network. These are examples)
Lastly, the .netdev rule /etc/systemd/network/br0.netdev
Finally, reboot (because that way you'll know if it persists through a reboot and/or if there are other issues.
Once rebooted, you can use networkctl to check if it all worked.
Mine looked something like this:
IDX LINK TYPE OPERATIONAL SETUP
1 lo loopback carrier unmanaged
2 eth0 ether degraded configured
3 sit0 sit off unmanaged
4 ip6tnl0 tunnel6 off unmanaged
5 bond0 ether off unmanaged
6 br0 ether routable configured
7 lxcbr0 ether no-carrier unmanaged
7 links listed.
When I set this up, IPv6 autoconfiguration kicked in for the br0 adapter. So I presume that if you do have an IPv6 DHCP server on your network (or your ISP manages this for you), then you shouldn't need to worry about configuring IPv6 automatically (unless you need to).